Dodge 2000 DURANGO Service Manual page 465

DN
REMOVAL AND INSTALLATION (Continued)
(2) Remove the trim panel from the inner liftgate
panel. Refer to Group 23 - Body for the procedures.
(3) Remove the two screws that secure the power
lock motor to the liftgate inner panel (Fig. 4).
Fig. 4 Liftgate Power Lock Motor Remove/Install
1 – WIRE HARNESS CONNECTOR
2 – SCREW
3 – MOTOR
4 – LINK
(4) Pull the power lock motor out through the
access hole in the liftgate inner panel far enough to
access and unplug the wire harness connector.
(5) Lower the power lock motor far enough to
access and disengage the link from the liftgate latch
clip.
(6) Remove the power lock motor from the liftgate.
(7) Reverse the removal procedures to install.
Tighten the mounting screws to 3.3 N·m (30 in. lbs.).
DRIVER UNLOCK RELAY
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the steering column opening cover and
knee blocker from the instrument panel. Refer to
Steering Column Opening Cover and Knee Blocker in
the Removal and Installation section of Group 8E -
Instrument Panel Systems for the procedures.
(3) Reach through the outboard side of the steer-
ing column opening in the instrument panel to access
GROUP 8M - PASSIVE
STEERING COLUMN,
the relay and fuse block on the back of the junction
block (Fig. 5).
Fig. 5 Relay and Fuse Block
1 – JUNCTION BLOCK
2 – RELAY AND FUSE BLOCK
(4) Unplug the driver unlock relay from the relay
and fuse block.
(5) Install the driver unlock relay by aligning the
relay terminals with the cavities in the relay and
fuse block and pushing the relay firmly into place.
(6) Connect the battery negative cable.
(7) Test the relay operation.
(8) Reverse the remaining removal procedures to
complete the installation.
HEADLAMP RELAY
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the cover from the Power Distribution
Center (PDC) (Fig. 6).
(3) Refer to the label on the PDC for headlamp
relay identification and location.
(4) Unplug the headlamp relay from the PDC.
(5) Install the headlamp relay by aligning the
relay terminals with the cavities in the PDC and
pushing the relay firmly into place.
POWER LOCK SYSTEMS
TO GROUP 8M
STEERING COLUMN,
8P - 9
- PASSIVE
OR