Floor Carpet - Dodge 2000 DURANGO Service Manual

DN
REMOVAL AND INSTALLATION (Continued)
(4) Install screws attaching floor console to floor
pan (Fig. 98).
(5) Install forward and rearward cup holder inserts.

FLOOR CARPET

FRONT CARPET REMOVAL
(1) Remove floor console, if equipped.
(2) Remove front seats.
(3) Remove center console, if equipped.
(4) Remove 2nd row seats.
(5) Remove 3rd row seats, if equipped.
(6) Remove front and rear door sill trim.
(7) Remove lower left and right cowl trim.
(8) Remove left and right B-pillar trim.
(9) Remove left and right quarter panel trim.
(10) Loosen gas pedal bracket.
(11) Remove rear fresh air vent.
(12) Route wiring through carpet.
(13) Remove carpet from vehicle (Fig. 99).
FRONT CARPET INSTALLATION
(1) Position carpet in vehicle and align all holes.
(2) Route all wire harnesses through openings in
carpet.
(3) Install front and rear door sill trim.
(4) Install quarter panel trim.
1 – FRONT CARPET
2 – REAR CARPET
(5) Install B-pillar trim.
(6) Install lower cowl trim.
(7) Tighten gas pedal bracket.
(8) Install 3rd row seats, if equipped.
(9) Install 2nd row seats.
(10) Install rear fresh air vent.
(11) Install center console, if equipped.
(12) Install front seats.
(13) Install floor console, if equipped.
REAR CARPET REMOVAL
(1) Remove 3rd row seats, if equipped.
(2) Remove 3rd row seat belt/buckles, if equipped.
(3) Remove left and right quarter panel trim.
(4) Remove liftgate scuff plate.
(5) Remove screws attaching cargo compartment
lid hinge to floor.
(6) Remove carpet from vehicle (Fig. 99).
REAR CARPET INSTALLATION
(1) Position carpet in vehicle and align all holes.
(2) Install screws attaching cargo compartment lid
hinge to floor.
(3) Install liftgate scuff plate.
(4) Install quarter panel trim.
(5) Install 3rd row seat belt/buckles, if equipped.
(6) Install 3rd row seats, if equipped.
Fig. 99 Floor Carpet
3 – STORAGE COMPARTMENT LINER
4 – PLASTIC PUSH-IN NUT
BODY 23 - 63