Dodge 2000 DURANGO Service Manual page 331

DN
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
(1) Install the cigar lighter or power outlet mount
into the instrument panel lower bezel.
(2) Align the splines on the outside of the cigar
lighter or power outlet receptacle base connector
receptacle with the grooves on the inside of the
mount.
(3) Press firmly on the cigar lighter or power out-
let receptacle base until the retaining bosses of the
mount are fully engaged in their receptacles.
(4) Install the cigar lighter knob and element into
the cigar lighter receptacle base, or the protective cap
into the power outlet receptacle base.
(5) Install the lower bezel onto the instrument
panel. Refer to Instrument Panel Lower Bezel in
the Removal and Installation section of this group for
the procedures.
(6) Reconnect the battery negative cable.
GLOVE BOX LAMP AND SWITCH
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Open the glove box.
(3) Reach through the glove box opening and
behind the glove box opening upper reinforcement in
the instrument panel to access and depress the
retaining latches on the top and bottom of the glove
box lamp and switch housing.
(4) While holding the retaining latches depressed,
push the glove box lamp and switch out through the
mounting hole in the instrument panel glove box
opening upper reinforcement (Fig. 17).
(5) Pull the glove box lamp and switch out from
the mounting hole far enough to access the wire har-
ness connector.
(6) Disconnect the instrument panel wire harness
connector from the glove box lamp and switch con-
nector receptacle.
(7) Remove the glove box lamp and switch from
the instrument panel.
GROUP 8M - PASSIVE
STEERING COLUMN,
INSTRUMENT PANEL SYSTEMS
Fig. 17 Glove Box Lamp and Switch Remove/Install
1 – GLOVE BOX LAMP AND SWITCH
2 – CONNECTOR
INSTALLATION
(1) Position the glove box lamp and switch to the
instrument panel.
(2) Reconnect the instrument panel wire harness
OR
connector to the glove box lamp and switch connector
receptacle.
(3) Feed the instrument panel wire harness back
into the glove box lamp and switch mounting hole in
the glove box opening upper reinforcement.
(4) Align the glove box lamp and switch housing
with the mounting hole in the instrument panel
glove box opening upper reinforcement.
(5) Push the glove box lamp and switch into the
mounting hole in the instrument panel glove box
opening upper reinforcement until the retaining
latches are fully engaged.
(6) Close the glove box.
(7) Reconnect the battery negative cable.
GLOVE BOX LATCH STRIKER
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER
RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING WHEEL,
INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND POSSIBLE PERSONAL
INJURY.
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Open the glove box.
TO GROUP 8M -
STEERING COLUMN,
8E - 23
PASSIVE
OR