Dodge 2000 DURANGO Service Manual page 374

8H - 8 SPEED CONTROL SYSTEM
REMOVAL AND INSTALLATION (Continued)
Fig. 9 Cowl Grille Panel Weather-strip
1 – COWL GRILLE
2 – WEATHERSTRIP
(5) Remove two plastic rivets securing each side of
the cowl plenum cover/grille panel to cowl plenum
panel and cowl top panel.
(6) Lift cowl plenum cover/grille panel from vehicle
far enough to access windshield washer and vacuum
plumbing near right end of cowl plenum.
(7) Disconnect windshield washer supply hose at
in-line connector.
(8) Disconnect vacuum supply hose from vacuum
supply connector at vacuum reservoir (Fig. 8).
1 – PLASTIC RIVET
2 – IN-LINE WASHER SUPPLY HOSE CONNECTOR
3 – STUD
Fig. 10 Cowl Plenum Cover/Grille Panel Remove/Install
(9) Remove cowl plenum cover/grille panel from
vehicle.
(10) Remove three reservoir mounting screws (Fig.
8).
(11) Remove vacuum reservoir from vehicle.
INSTALLATION
(1) Install vacuum reservoir and three mounting
screws to plastic cowl cover. Tighten three screws to
2.2 N·m (20 in. lbs.) torque.
(2) Position cowl plenum cover/grille panel to vehi-
cle.
(3) Connect vacuum supply hose to vacuum reser-
voir.
(4) Connect windshield washer supply hose at in-
line connector.
(5) Install and tighten cowl cover fasteners to vehi-
cle body.
(6) Install rubber weather-strip at front edge of
cowl grill.
(7) Install windshield wiper arms. Refer to Group
8K, Wiper and Washer Systems.
(8) Connect negative battery to cable.
4 – PLASTIC NUT
5 – COWL PLENUM COVER/GRILLE PANEL
DN