Dodge 2000 DURANGO Service Manual page 352

8F - 12 AUDIO SYSTEMS
REMOVAL AND INSTALLATION (Continued)
(6) From the outside of the steering wheel rear
trim cover, remove the remote radio switch from the
trim cover mounting hole.
INSTALLATION
(1) Position the remote radio switch to the mount-
ing hole on the outside of the steering wheel rear
trim cover. Be certain that the connector receptacle is
oriented toward the bottom of the switch and pointed
toward the center of the steering wheel.
(2) Press firmly and evenly on the remote radio
switch until each of the switch latches is fully
engaged in the mounting hole of the steering wheel
rear trim cover.
(3) Reconnect the steering wheel wire harness con-
nector to the connector receptacle of the remote radio
switch.
(4) Install the speed control switch onto the steer-
ing wheel. Refer to Speed Control Switches in the
Removal and Installation section of Group 8H -
Speed Control System for the procedures.
(5) Install the driver side airbag module onto the
steering wheel. Refer to Driver Side Airbag Mod-
ule in the Removal and Installation section of Group
8M - Passive Restraint Systems for the procedures.
(6) Reconnect the battery negative cable.
SPEAKER
REMOVAL
FRONT DOOR UPPER SPEAKER
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the trim panel from the front door.
Refer to Front Door Trim Panel in the Removal
and Installation section of Group 23 - Body for the
procedures.
(3) Disconnect the door wire harness connector
from the front door upper speaker wire harness con-
nector (Fig. 7).
(4) Remove the two screws that secure the front
door upper speaker to the back of the trim panel.
(5) Remove the front door upper speaker from the
trim panel.
FRONT DOOR LOWER SPEAKER
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the trim panel from the front door.
Refer to Front Door Trim Panel in the Removal
and Installation section of Group 23 - Body for the
procedures.
(3) Remove the three screws that secure the
speaker to the front door inner panel (Fig. 8).
Fig. 7 Front Door Upper Speaker Remove/Install
1 – POWER MIRROR SWITCH
2 – TWEETER
3 – POWER WINDOW SWITCH
4 – WIRE HARNESS CONNECTOR
Fig. 8 Front Door Lower Speaker Remove/Install
1 – SPEAKER
2 – SCREW
3 – CONNECTOR
(4) Pull the speaker away from the mounting hole
in the front door inner panel far enough to access the
wire harness connector.
(5) Disconnect the front door wire harness connec-
tor from the speaker connector receptacle.
(6) Remove the speaker from the front door inner
panel.
DN