Rear Blower Motor Switch - Dodge 2000 DURANGO Service Manual

DN
REMOVAL AND INSTALLATION (Continued)
Fig. 76 Floor-Defrost Door Actuator Remove/Install
1 – FLOOR-DEFROST DOOR CRANK ARM
2 – SCREWS
3 – FLOOR-DEFROST DOOR ACTUATOR
4 – VACUUM CONNECTORS
5 – PUSH NUT
the Removal and Installation section of Group 8E -
Instrument Panel Systems for the procedures.
(3) Unplug the vacuum harness connector from the
panel-defrost door actuator (Fig. 77).
(4) Remove the two screws that secure the panel-
defrost door actuator to the heater-A/C housing.
(5) Rotate the panel-defrost door actuator clock-
wise about one-quarter turn to disengage the hooked
end of the actuator link from the hole on the end of
the panel-defrost door lever.
(6) Remove the panel-defrost door actuator from
the heater-A/C housing.
(7) Reverse the removal procedures to install.
Tighten the panel-defrost door actuator mounting
screws to 2.2 N·m (20 in. lbs.).
RECIRCULATION AIR DOOR ACTUATOR
A recirculation air door and vacuum actuator are
used only on models with the optional air condition-
ing system.
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the instrument panel assembly from
the vehicle. Refer to Instrument Panel Assembly in
the Removal and Installation section of Group 8E -
Instrument Panel Systems for the procedures.
HEATING AND AIR CONDITIONING
Fig. 77 Panel-Defrost Door Actuator
1 – VACUUM CONNECTOR
2 – SCREW
3 – PANEL-DEFROST DOOR ACTUATOR
4 – SCREW
5 – DEMISTER DUCT ADAPTER
(3) If the vehicle is so equipped, and the heater-
A/C housing is in its installed position in the vehicle,
remove the Infinity speaker system amplifier. Refer
to Amplifier in the Removal and Installation section
of Group 8F - Audio Systems for the procedures.
(4) Unplug the two vacuum harness connectors
from the recirculation air door actuator (Fig. 78).
(5) Remove the two stamped nuts that secure the
recirculation air door actuator to the blower motor
housing cover.
(6) Unhook the actuator link from the recirculation
air door lever.
(7) Remove the actuator from the blower motor
housing cover.
(8) Reverse the removal procedures to install.
Tighten the mounting nuts until the recirculation air
door actuator is seated to the blower motor housing
cover.

REAR BLOWER MOTOR SWITCH

The rear blower motor switch is used only on mod-
els with the optional rear overhead air conditioning
unit.
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Using a trim stick or another suitable wide
flat-bladed tool, gently pry above the two indenta-
tions at the outer perimeter of the rear blower motor
switch to release it from the headliner (Fig. 79).
24 - 63