3Rd Row Seat Belt Buckle; Bucket Seat - Dodge 2000 DURANGO Service Manual

DN
REMOVAL AND INSTALLATION (Continued)
1 – D-PILLAR
2 – RETRACTOR
3 – ANTI-RATTLE CUP
4 – BUCKLE
5 – ANCHOR BOLT

3RD ROW SEAT BELT BUCKLE

REMOVAL
(1) Move 3rd row seat cushion to cargo position.
(2) Remove bolt attaching seat belt buckle to floor
pan.
(3) Separate seat belt buckle from vehicle (Fig. 93).
INSTALLATION
(1) Position seat belt buckle in vehicle (Fig. 93).
(2) Install bolt attaching seat belt buckle to floor
pan. Tighten bolt to 39 N·m (29 ft. lbs.) torque.
(3) Move 3rd row seat cushion to seating position.

BUCKET SEAT

REMOVAL
If vehicle is equipped with center seat/console,
remove seats and console as one assembly.
(1) If equipped, remove side shield and disengage
power seat switch connector.
(2) Move seat to full forward position.
Fig. 92 3rd Row Seat Belt Retractor
6 – STUD
7 – BELT ANCHOR
8 – TURNING LOOP
9 – D-PILLAR TRIM
(3) Remove rear screws attaching trim cover to
seat track (Fig. 94).
(4) Remove rear bolts attaching rear seat track to
floor pan.
(5) Move seat to full rearward position.
(6) Remove front screws attaching trim cover to
seat track (Fig. 94).
(7) Remove front bolts attaching front seat track to
floor pan.
NOTE: Do not actuate recliner or track adjuster
once bolts are removed.
(8) Tilt setback forward and lift seat out through
door.
INSTALLATION
(1) Position seat in vehicle.
(2) Install bolts attaching front seat track to floor
pan. Tighten bolts in sequence:
(a) Driver's seat:
(I) Front outboard
(II) Front inboard
(b) Passenger's seat:
BODY 23 - 59