Dodge 2000 DURANGO Service Manual page 284

8C - 4 CHARGING SYSTEM
REMOVAL AND INSTALLATION (Continued)
Fig. 3 Generator Connectors—Typical Bosch
1 – FIELD WIRE CONNECTOR
2 – FIELD WIRES
3 – B+ (OUTPUT TERMINAL)
Fig. 4 Generator Connectors—Typical Denso
1 – FIELD WIRES
2 – B+ (OUTPUT TERMINAL)
3 – FIELD WIRE CONNECTOR
INSTALLATION
(1) Position generator to engine and snap field
wire connector into rear of generator.
(2) Install B+ terminal to generator mounting
stud. Tighten mounting nut to 8.5 N·m (75 in. lbs.)
torque.
(3) Install generator
tighten as follows:
• Generator
mounting
engines—41 N·m (30 ft. lbs.) torque.
• Generator
pivot
engines—41 N·m (30 ft. lbs.) torque.
• Vertical mounting bolt 4.7L engine—55 N·m (40
ft. lbs.)
• Long horizontal mounting bolt 4.7L engine—55
N·m (40 ft. lbs.)
• Short horizontal mounting bolt 4.7L engine—74
N·m (55 ft. lbs.)
CAUTION: Never force a belt over a pulley rim
using a screwdriver. The synthetic fiber of the belt
can be damaged.
CAUTION: When installing a serpentine accessory
drive belt, the belt MUST be routed correctly. The
water pump will be rotating in the wrong direction if
the belt is installed incorrectly, causing the engine
to overheat. Refer to belt routing label in engine
compartment, or refer to Belt Schematics in Group
7, Cooling System.
(4) Install generator drive belt. Refer to Group 7,
Cooling System for procedure.
(5) Snap cable protector cover to B+ mounting stud
(if equipped).
(6) Install negative battery cable to battery.
BATTERY TEMPERATURE SENSOR
The battery temperature sensor is located under
vehicle battery (Fig. 5) and is attached to a mounting
hole on battery tray.
REMOVAL
(1) Remove battery. Refer to Group 8A, Battery for
procedures.
mounting fasteners
bolt—3.9L/5.2L/5.9L
bolt/nut—3.9L/5.2L/5.9L
DN
and