Dodge 2000 DURANGO Service Manual page 372

8H - 6 SPEED CONTROL SYSTEM
REMOVAL AND INSTALLATION (Continued)
SERVO CABLE (EXCEPT 4.7L ENGINE)
REMOVAL
(1) Disconnect negative battery cable at battery.
(2) Using finger pressure only, remove speed con-
trol cable connector at throttle body bellcrank by
pushing connector off the bellcrank pin (Fig. 4). DO
NOT try to pull connector off perpendicular to
the bellcrank pin. Connector will be broken.
Fig. 4 Cable Connection at Throttle Body
1 – VEHICLE SPEED CONTROL CABLE
(3) Squeeze 2 tabs on sides of speed control cable
at throttle body mounting bracket (locking plate) and
push out of bracket.
(4) Remove servo cable from servo. Refer to Speed
Control Servo Removal/Installation in this group.
INSTALLATION
(1) Install end of cable to speed control servo.
Refer to Speed Control Servo Removal and Installa-
tion in this group.
(2) Install cable into throttle body mounting
bracket (snaps in).
(3) Install speed control cable connector at throttle
body bellcrank pin (snaps on).
(4) Connect negative battery cable at battery.
(5) Before starting engine, operate accelerator
pedal to check for any binding.
SERVO CABLE—4.7L V-8 ENGINE
REMOVAL
(1) Disconnect negative battery cable at battery.
(2) Remove air box housing from throttle body.
The accelerator cable must be partially removed to
gain access to speed control cable.
(3) Using finger pressure only, disconnect accelera-
tor cable connector at throttle body bellcrank pin by
pushing connector off bellcrank pin towards front of
vehicle (Fig. 5). DO NOT try to pull connector off
perpendicular to the bellcrank pin. Connector
will be broken.
(4) Lift accelerator cable from top of cable cam
(Fig. 5).
(5) Press tab (Fig. 6) to release plastic cable mount
from bracket. Press on tab only enough to
release cable from bracket. If tab is pressed too
much, it will be broken. Slide plastic mount (Fig.
6) towards passenger side of vehicle to remove cable
from bracket.
(6) Using finger pressure only, disconnect speed
control cable connector at throttle body bellcrank pin
by pushing connector off bellcrank pin towards front
of vehicle (Fig. 5). DO NOT try to pull connector
off perpendicular to the bellcrank pin. Connec-
tor will be broken.
(7) Slide speed control cable plastic mount towards
passenger side of vehicle to remove cable from
bracket (Fig. 7).
(8) Remove servo cable from servo. Refer to Speed
Control Servo Removal/Installation.
Fig. 5 Cable Connectors at Bell Crank—4.7L V-8
1 – THROTTLE BODY
2 – SPEED CONTROL CABLE CONNECTOR
3 – OFF
4 – OFF
5 – ACCELERATOR CABLE CONNECTOR
6 – CABLE CAM
7 – BELLCRANK
INSTALLATION
(1) Install end of cable to speed control servo.
Refer to Speed Control Servo Removal/Installation.
(2) Slide speed control cable plastic mount into
bracket.
Engine
DN