23 - 66
BODY
REMOVAL AND INSTALLATION (Continued)
Fig. 105 Overhead Assist Handle
1 – RIV-NUT
2 – OVERHEAD ASSIST HANDLE
HEADLINER
REMOVAL
(1) Disconnect battery negative cable.
(2) Remove sunvisors and sunvisor arm supports.
(3) Remove coat hooks.
(4) Remove overhead assist handle.
(5) Remove dome lamp.
(6) Remove overhead console, if equipped.
(7) Remove outlet bezel for rear air conditioner, if
equipped.
(8) Remove blower control switch for rear air con-
ditioner, if equipped.
(9) Remove upper liftgate opening trim.
(10) Disengage A-pillar, B-pillar, C-pillar, and
D-pillar trim as necessary to prevent trim panel
interference.
(11) Move 2nd row seats to cargo position.
(12) Move front seats to full recline position.
(13) Move 3rd row seat to cargo position, if
equipped.
(14) Remove push-in fasteners attaching headliner
to roof panel (Fig. 107).
(15) Carefully bow headliner and remove through
the liftgate opening (Fig. 106).
INSTALLATION
(1) Carefully bow headliner and slide through the
liftgate opening (Fig. 106).
(2) Install push-in fasteners attaching headliner to
roof panel (Fig. 107).
(3) Engage A-pillar, B-pillar, C-pillar, and D-pillar
trim.
(4) Install upper liftgate opening trim.
(5) Install blower control switch for rear air condi-
tioner, if equipped.
Fig. 106 Headliner
1 – HEADLINER
Fig. 107 Headliner Push-in Fasteners
1 – HEADLINER
2 – PUSH-IN FASTENER
(6) Install outlet bezel for rear air conditioner, if
equipped.
(7) Install overhead console, if equipped.
(8) Install dome lamp.
(9) Install overhead assist handle.
(10) Install coat hooks.
(11) Install sunvisors and sunvisor arm supports.
(12) Return seats to seating position.
(13) Connect battery negative cable.
ADJUSTMENTS
HOOD
(1) Loosen the hinge arm-to-hood panel bolts at
each side of the vehicle.
(2) Loosen the hood latch screws.
DN