Dodge 2000 DURANGO Service Manual page 421

DN
REMOVAL AND INSTALLATION (Continued)
Fig. 9 Underhood Lamp Removal
1 – HOOD
2 – UNDERHOOD LAMP
INSTALLATION
(1) Install bulb.
(2) Install lamp lens.
(3) Position the underhood lamp on the hood inner
panel.
(4) Install the attaching screw through the lamp
and into the hood panel (Fig. 9). Tighten the screw
securely.
(5) Fold lamp housing over and firmly press onto
base to snap into place.
(6) Connect the wire harness connector to the
lamp.
DOME LAMP
REMOVAL
(1) Using a small flat blade, pry the left side (driv-
er's side) of the dome lamp lens downward from
dome lamp.
(2) Allow the lens to hang down, this will disen-
gage the right side of the lamp (passenger's side)
from the headliner.
(3) Pull the right side of the lamp down and slide
the lamp to the right.
(4) Separate the lamp from the headliner.
(5) Disengage dome lamp wire connector from body
wire harness.
(6) Separate dome lamp from vehicle (Fig. 10) and
(Fig. 11).
Fig. 10 Front Dome Lamp
1 – DOME LAMP
2 – HEADLINER
Fig. 11 Rear Dome Lamp
1 – HEADLINER
2 – DOME LAMP
INSTALLATION
(1) Position dome lamp at headliner.
(2) Connect dome lamp wire connector to body
wire harness.
(3) Position the left side of the lamp in the head-
liner opening and slide lamp to the left.
(4) Push the right side of the lamp in the head-
liner opening and push the lamp lens up into the
lamp to secure.
2ND SEAT DOME/READING LAMP
REMOVAL
(1) Using a small flat blade, pry the center rear-
ward edge of the dome/reading lamp lens downward
from lamp (Fig. 12).
LAMPS 8L - 19