Dodge 2000 DURANGO Service Manual page 506

8V - 12 OVERHEAD CONSOLE SYSTEMS
REMOVAL AND INSTALLATION (Continued)
(3) Remove the two screws that secure the reading
and courtesy lamp housing to the overhead console
housing (Fig. 8).
Fig. 8 Overhead Console Reading and Courtesy
Lamp Housing Remove/Install
1 – COMPASS MINI-TRIP COMPUTER
2 – SLOT
3 – SUNGLASSES STORAGE BIN DAMPER SPRING
4 – OVERHEAD CONSOLE READING AND COURTESY LAMP
HOUSING
5 – SCREWS (2)
6 – BULB HOLDERS
7 – SWITCHES
(4) Pull the reading and courtesy lamp housing
away from the overhead console housing far enough
to turn it over for access to the lamp bulbs.
(5) Remove both reading and courtesy lamp bulbs
from their bulb holders by pulling them straight out
from the holders.
(6) Remove both switches from their mounting
slots by sliding them towards their respective out-
board ends of the reading and courtesy lamp housing.
(7) Remove the four bulb holders from their
mounting holes in the reading and courtesy lamp
housing by depressing the latch on each side of each
holder and pushing the bulb side of the holder out
through the wire side of the mounting hole.
(8) Remove the reading and courtesy lamp housing
from the overhead console housing.
INSTALLATION
(1) Install each of the four bulb holders into their
mounting holes in the reading and courtesy lamp
housing by inserting the bulb side of the holder into
the wire side of the mounting hole and pushing it
through the mounting hole until both latches are
engaged with the lamp housing.
(2) Install both switches into their mounting slots
by sliding them inboard from their respective ends of
the reading and courtesy lamp housing until they
snap into place.
(3) Install both reading and courtesy lamp bulbs
into their bulb holders by pushing them straight into
the holders.
(4) Position the reading and courtesy lamp housing
onto the overhead console housing. Be certain that
the sunglasses storage bin damper spring is engaged
in the slot on the rear flange of the reading and cour-
tesy lamp housing.
(5) Install and tighten the two screws that secure
the reading and courtesy lamp housing to the over-
head console housing. Tighten the screws to 2.2 N·m
(20 in. lbs.).
(6) Install the compass mini-trip computer module
into the overhead console housing. Refer to Compass
Mini-Trip Computer in the Removal and Installa-
tion section of this group for the procedures.
(7) Reconnect the battery negative cable.
SUNGLASSES STORAGE BIN
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the reading and courtesy lamp housing
from the overhead console. Refer to Overhead Con-
sole Reading and Courtesy Lamp Housing in the
Removal and Installation section of this group for the
procedures.
(3) Unlatch and remove the sunglasses storage bin
from the overhead console housing.
INSTALLATION
(1) Position the sunglasses storage bin into the
overhead console housing.
(2) Engage the latch of the sunglasses storage bin
with the latch striker on the rear of the storage bin
opening in the overhead console housing.
(3) Be certain that the sunglasses storage bin pivot
shaft is located in the two pivot receptacles just
behind the reading and courtesy lamp lenses in the
overhead console housing.
(4) Be certain that the sunglasses storage bin
damper spring is installed on the pivot shaft with the
two end tabs of the spring engaged with the flats on
the rear of the shaft, and the center tab engaged over
the front of the shaft.
(5) Install the reading and courtesy lamp housing
onto the overhead console. Refer to Overhead Con-
sole Reading and Courtesy Lamp Housing in the
Removal and Installation section of this group for the
procedures.
(6) Reconnect the battery negative cable.
DN