Dodge 2000 DURANGO Service Manual page 784

19 - 8 STEERING
REMOVAL AND INSTALLATION (Continued)
Fig. 3 Pump Assembly
1 – PUMP ASSEMBLY
2 – BOLTS
Fig. 4 Pump Mounting Bracket
1 – PULLEY
2 – PUMP BRACKET
3 – STEERING PUMP
4 – BOLT
(6) Install the serpentine drive belt refer to Group
7 Cooling.
(7) Fill the reservoir with power steering fluid,
refer to Power Steering Pump Initial–Operation.
POWER STEERING PUMP - 4.7L
REMOVAL
(1) Remove the serpentine drive belt, refer to
Group 7 Cooling.
(2) Remove return hose from the pump reservoir
and drain the pump.
(3) Remove power steering pressure switch connec-
tor and remove pressure line from the bottom of the
pump.
(4) Remove the oil cooler mounting bolt from the
pump bracket if equipped.
(5) Remove 3 pump mounting bolts (Fig. 5)
through pulley access holes.
(6) Remove the pump from the left cylinder head.
Fig. 5 Power Steering Pump - 4.7L
1 – PUMP
2 – MOUNTING BOLTS
INSTALLATION
(1) Align the pump with the mounting holes in the
left cylinder head.
(2) Install 3 pump mounting bolts through the pul-
ley access holes. Tighten the bolts to 28 N·m (21 ft.
lbs.).
(3) Install the oil cooler to the pump bracket if
equipped. Install the oil cooler mounting bolt.
(4) Install the pressure line and return hose to the
pump. Tighten the pressure line to 35 N·m (25 ft.
lbs.).
(5) Install power steering pressure switch connec-
tor.
(6) Install the serpentine drive belt, refer to Group
7 Cooling.
(7) Fill the power steering pump and perform
Power Steering Pump Initial Operation.
DN