Dodge 2000 DURANGO Service Manual page 413

DN
REMOVAL AND INSTALLATION (Continued)
PARK AND TURN SIGNAL LAMP BULBS
REMOVAL
(1) Remove park and turn signal lamp.
(2) Rotate bulb socket 1/4 turn counterclockwise
and pull turn signal lamp socket from back of lamp
(Fig. 3).
(3) Pull park and turn signal lamp bulb from
socket.
Fig. 3 Park And Turn Signal Lamp bulb
1 – SIDE MARKER LAMP BULB
2 – PARK/TURN SIGNAL LAMP BULB
INSTALLATION
(1) Install park and turn signal lamp bulb in
socket.
(2) Install park and turn signal lamp socket into
back of lamp.
(3) Install park/turn signal lamp.
FRONT SIDE MARKER LAMP BULB
REMOVAL
(1) Remove park and turn signal lamp.
(2) Remove side marker lamp socket from back of
lamp (Fig. 1).
(3) Pull side marker lamp bulb from socket.
INSTALLATION
(1) Install side marker lamp bulb in socket.
(2) Install side marker lamp socket into back of
lamp.
(3) Install park/turn signal lamp.
CENTER HIGH MOUNTED STOP LAMP
(CHMSL) BULB
REMOVAL
(1) Remove CHMSL from liftgate.
(2) Turn bulb socket 1/4 turn counterclockwise.
(3) Separate socket from lamp.
(4) Grasp bulb and pull from socket.
INSTALLATION
(1) Position bulb in socket and press into place.
(2) Position socket in lamp.
(3) Turn bulb socket 1/4 turn clockwise.
(4) Install CHMSL.
LIFTGATE/CARGO LAMP BULB
REMOVAL
(1) Remove liftgate/cargo lamp from liftgate.
(2) Using a small flatblade, pry lamp lens from
lamp.
(3) Remove bulb from lamp.
INSTALLATION
(1) Install in bulb in lamp.
(2) Install lamp lens on lamp.
(3) Install liftgate/cargo lamp in liftgate.
TAIL, BRAKE, TURN SIGNAL AND BACK-UP
LAMP BULB
REMOVAL
(1) Release liftgate latch and open liftgate.
(2) Remove screws attaching tail, brake, turn sig-
nal and back-up lamp to liftgate opening.
(3) Separate inner end of lamp from quarter panel.
(4) Disengage hook holding outer end of lamp to
quarter panel opening.
(5) Separate lamp from quarter panel.
(6) Rotate lamp socket counterclockwise one quar-
ter turn (Fig. 4).
(7) Pull socket from back of lamp.
(8) Pull bulb from socket (Fig. 5).
INSTALLATION
(1) Align key on bulb base to groove in socket and
insert bulb into socket (Fig. 5).
(2) Insert socket into back of lamp.
(3) Rotate lamp socket clockwise one quarter turn.
(4) Engage hook to hold outer end of lamp to quar-
ter panel opening.
(5) Place lamp in position on quarter panel.
(6) Install screws attaching lamp to liftgate open-
ing.
LAMPS 8L - 11