Dodge 2000 DURANGO Service Manual page 451

DN
REMOVAL AND INSTALLATION (Continued)
(6) Disconnect the engine wire harness in-line con-
nector from the PDC connector receptacle (Fig. 5).
Fig. 5 Engine Wire Harness In-Line Connector
1 – COVER
2 – POWER DISTRIBUTION CENTER
3 – ENGINE WIRE HARNESS IN-LINE CONNECTOR
4 – CLIP
(7) Slide the engine wire harness retainer clip
upward and disengage the harness from the trough
on the rear of the PDC housing.
(8) Remove the nut that secures the eyelet of the
battery negative cable generator output take out to
the rearward B(+) terminal stud in the PDC and
remove the eyelet from the stud (Fig. 6).
(9) Remove the nut that secures the eyelet of the
battery positive cable PDC take out to the forward
B(+) terminal stud in the PDC and remove the eyelet
from the stud.
(10) Remove the screw that secures the PDC hous-
ing to the left front fender wheel housing (Fig. 7).
(11) Disengage the latches for the two PDC
mounts and lift the unit off of the battery tray stan-
chions.
(12) Remove the PDC and the headlamp and dash
wire harness from the engine compartment as a unit.
INSTALLATION
NOTE: If the PDC is being replaced with a new unit,
be certain to transfer each of the blade-type fuses,
cartridge fuses and relays from the faulty PDC to
the proper cavities of the replacement PDC. Refer
to Power Distribution in the index of this service
manual for the location of complete PDC circuit dia-
grams and cavity assignments.
POWER DISTRIBUTION SYSTEMS
Fig. 6 Battery and Generator Connections to PDC
1 – POWER DISTRIBUTION CENTER
2 – COVER
3 – NUT
4 – BATTERY POSITIVE CABLE PDC TAKE OUT
5 – BATTERY NEGATIVE CABLE GENERATOR OUTPUT TAKE
OUT
6 – NUT
Fig. 7 Power Distribution Center Remove/Install
1 – POWER DISTRIBUTION CENTER
2 – BATTERY TRAY
3 – LEFT FRONT FENDER WHEEL HOUSING
4 – SCREW
8O - 5