Assigning Static Mvr6 Multicast Groups To Interfaces - Edge-Core ES3528MV2 Management Manual

Use the Multicast > MVR6 (Configure Static Group Member) page to
A S
SSIGNING TATIC
statically bind multicast groups to a port which will receive long-term
MVR6 M
ULTICAST
multicast streams associated with a stable set of hosts.
G
ROUPS TO
I
NTERFACES
CLI R
◆
C
OMMAND
◆
◆
◆
P
ARAMETERS
These parameters are displayed:
◆
◆
◆
◆
W
EB
To assign a static MVR6 group to an interface:
1.
2.
3.
4.
5.
6.
EFERENCES
"mvr6 vlan group" on page 1287
U
SAGE
Multicast groups can be statically assigned to a receiver port using this
configuration page.
All IPv6 addresses must be according to RFC 2373 "IPv6 Addressing
Architecture," using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields. (Note that the IP
address ff02::X is reserved.)
The MVR6 VLAN cannot be specified as the receiver VLAN for static
bindings.
Domain ID – An independent multicast domain. (Range: 1-5)
Interface – Port or trunk identifier.
VLAN – VLAN identifier. (Range: 1-4094)
Group IPv6 Address – Defines a multicast service sent to the selected
port. Multicast groups must be assigned from the MVR6 group range
configured on the Configure General page.
I
NTERFACE
Click Multicast, MVR6.
Select Configure Static Group Member from the Step list.
Select Add from the Action list.
Select an MVR6 domain.
Select a VLAN and interface to receive the multicast stream, and then
enter the multicast group address.
Click Apply.
– 669 –
| Multicast Filtering
C 17
HAPTER
Multicast VLAN Registration for IPv6