Modifying The Lan Interface (Nat / Routing) - Planet Networking & Communication CS-2001 User Manual

3.1.1 Modifying the LAN Interface (NAT / Routing)

Prerequisite Setup (Note: IP addresses used as examples only)
Port1 is configured as LAN1 by default. (IP address: 192.168.1.1, NAT/ Routing)
Step 1. Go to Network > Interface and then set as below:

Click Port1's Modify button.

Select LAN for Interface Type.

Select NAT Routing for Connection Type.

Enter the IPv4 Address and Netmask.

Tick Ping, HTTP and HTTPS.

Click OK.
Note：
1. The LAN subnet is configured as 192.168.1.x/24 by default. After modifying the LAN subnet,
LAN PCs' subnet must be modified as well for the LAN users to access the Web UI.
2. Do not disable HTTP and HTTPS before configuring the settings under System >
Administration > Permitted IPs, or the IT administrator may be unable to access the Web
UI from LAN.
Figure 3-1 Modifying the LAN Interface
92
（Figure 3-1）