Planet Networking & Communication CS-2001 User Manual page 136

4.1.1 Using DHCP to Assign an IP to a Specific User and only
Permitting FTP Access
Step 1. Under Policy Object > Address > LAN, set as below:

Click New Entry. Type the name of the user in the Name field. (e.g.,
Alex).

Address type: Select either IP / Netmask or IP Range.

IP Version: Select IPv4 or IPv6.

Type the IP address of the user in the IP Address field. (e.g.,
192.168.3.2)

Netmask: Type "255.255.255.255" (denotes a single IP address as
specified in the IP Address field).

Type the MAC address of the user in the MAC Address field. (e.g.,
00:B0:18:25:F5:89)

Select the Interface from the Interface drop-down list.

Click OK. （Figure 4-2）
Figure 4-1 Adding a LAN Address
Figure 4-2 The Added LAN Address
135
（Figure 4-1）