Planet Networking & Communication CS-2001 User Manual page 241

Step 6. Go to Policy > Outgoing and set as below:

Select the defined rule from the Source Address drop-down list.

Select Mail_Service from the Service drop-down list.

Click OK.
Important：
1. To enable the LAN to LAN connection, go to Policy > LAN to LAN and create a policy
(select Inside Any for both Source Address and Destination Address). To enable the DMZ to
DMZ connection, go to Policy > DMZ to DMZ and create a policy (select DMZ Any for both
Source Address and Destination Address).
（Figure 10-31）
Figure 10-30 Configuring an Outgoing Policy
Figure 10-31 Policy Completed
240
（Figure 10-30）