Planet Networking & Communication CS-2001 User Manual page 226

Step 6. Under Policy > Outgoing, set as below:

Source Address: Select the LAN address.

Service: Select Mail_Service.

Click OK.
Important:
1. To enable the LAN to LAN connection, go to Policy > LAN to LAN and create a policy
(select Inside Any for both Source Address and Destination Address). To enable the DMZ to
DMZ connection, go to Policy > DMZ to DMZ and create a policy (select DMZ Any for both
Source Address and Destination Address).
（Figure 10-7）
Figure 10-6 Configuring an Outgoing Policy
Figure 10-7 The Completed Policy Settings
225
(Figure 10-6)