Planet Networking & Communication CS-2001 User Manual page 127

Step 2. Go to Network > Interface and then set as below:

Click Port2's Modify button.

Select LAN for Interface Type.

Select NAT/Routing for Connection Type.

Enter the IPv4 Address and the Netmask.

Tick Ping, HTTP and HTTPS.

Click OK.
Step 3. Go to Network > Interface and set as below:

Click Port3's Modify button.

Select LAN for Interface Type.

Select Transparent Bridging for Connection Type.

Tick Ping, HTTP and HTTPS.

Click OK.
Figure 3-33 LAN Interface Settings
Figure 3-34 LAN Interface Settings
126
（Figure 3-33）
（Figure 3-34）