Planet Networking & Communication CS-2001 User Manual page 81

2.8.2 SNMP Trap Settings
Step 1. Go to System > Configuration > SNMP. Under the SNMP Trap Settings
section, configure the following settings:

Tick Enable SNMP trap alerts.

SNMP Trap Recipient Address: Type the IP address of the SNMP
Trap recipient.

Port: Type the port number of SNMP Trap. (Default value: 162)

Click OK.

The IT administrator may now install a SNMP Trap client to receive
alerts from the CS-2001.
Note:
1. The IT administrator may test the SNMP trap by clicking on
Figure 2-35 SNMP Trap Settings
80
（Figure 2-35）