Planet Networking & Communication CS-2001 User Manual page 235

Step 6. Under Policy > Outgoing, set as below:

Source IP: Select the address setting.

Service: Select the service setting.

Action: Select Port2 (WAN1)

Click OK.
Important：
1. To enable the LAN to LAN connection, go to Policy > LAN to LAN and create a policy
(select Inside Any for both Source Address and Destination Address). To enable the DMZ to
DMZ connection, go to Policy > DMZ to DMZ and create a policy (select DMZ Any for both
Source Address and Destination Address).
（Figure 10-21）
Figure 10-20 Setting an Outgoing Policy
Figure 10-21 The Completed Settings
234
（Figure 10-20）