Planet Networking & Communication CS-2001 User Manual page 686

Step 3. Go to Anomaly Flow IP > Settings and then set as below:

Enter the Traffic Threshold per IP. (The default value is 100)

Tick Enable Anomaly Flow IP Blocking and then type the Blocking
Time. (The default value is 60)

Tick Enable E-Mail Alert Notification.

Tick Enable SNMP trap alerts.

Tick Enable NetBIOS notification and then type the Administrator's
IP Address.

Click OK.
Note:
1. Detection-Excluded IP can be used for excluding specific IPs from detection.
2. Users whose PCs emit anomaly traffic flows can receive a customizable message in their
browser to alert them about the incident.
Figure 23-2 Anomaly Flow IP Setting
685
（Figure 23-2）