Planet Networking & Communication CS-2001 User Manual page 113

Step 1. Go to Network > Interface and then set as below:

Click Port1's Modify button.

Select LAN for Interface Type.

Select NAT Routing for Connection Type.

Enter the IPv4 Address and the Netmask.

Tick Ping, HTTP and HTTPS.

Click OK.
Step 2. Under Network > Interface, set as below:

Click Port3's Modify button.

Select DMZ for Interface Type.

Select Transparent Bridging for Connecion Type.

Tick Ping, HTTP and HTTPS.

Click OK.
Figure 3-19 LAN Interface Settings
Figure 3-20 DMZ Interface Settings
112
（Figure 3-19）
（Figure 3-20）