Planet Networking & Communication CS-2001 User Manual page 442

Step 2. Go to Mail Security > Configuration > Mail Relay and then set as below:
（Figure 12-35）

Select Sender's IP Address.

Type the IP Address and the Netmask.

Click OK.
Note：
1. In this example, the Mail Relay setting is used for determining the emails sent from the mail
server under DMZ1.
 If the recipient is an internal user (supportplanet.com.tw), the email will be recorded
under Mail Security > Mail Reports > Logs > Inbound SMTP after filtering.
 If the recipient is an external user, the email will be recorded under Mail Security > Mail
Reports > Logs > Outbound SMTP after filtering.
2. Given that a valid internal account sends an email to the extenal recipient upon the activation
of SMTP authentication, then there is no need to configure the Sender's IP Address under
Mail Security > Configuration > Mail Relay.
Figure 12-35 Mail Relay Settings
441