Folding The Back Support Up/Down; Settings; Prerequisites; Basic Settings - Otto Bock C1000 SF Instructions For Use Manual

Settings

See the power wheelchair instructions for use (user) for all information regarding the charging process.
The power wheelchair must be handed over to the user with fully charged batteries.

5.3 Folding the back support up/down

After unpacking, the backrest must be folded up and attached.
See the power wheelchair instructions for use (user) for more detailed information.
6 Settings

6.1 Prerequisites

WARNING
Making incorrect adjustments
Tipping over, falling or malposition of the user due to incorrect adjustments
► Adjustment and assembly work may be carried out only by qualified personnel.
► Only the adjustments described in these instructions for use may be carried out.
► Settings may only be changed within the allowable adjustment ranges; otherwise, the stability of the product
may be impaired (see this section and the "Technical data" section). If you have questions, contact the
manufacturer's service department (see inside back cover for addresses).
► Only conduct tests in the presence of an assistant.
► Unless expressly described, you may not change any settings with a person sitting in the product.
► Secure the user against falling out during all tests.
► Before testing setting changes with the user seated, firmly tighten all screw connections.
► Check for safe function before delivering the product.
CAUTION
Unsecured screw connections
Pinching, crushing, tipping over, falling of user due to assembly errors
► Always firmly re-tighten the mounting screws and nuts after changing settings. Observe the specified torques
in doing so.
► Any time you loosen a screw connection with thread lock, replace it with a new screw connection with thread
lock or secure the old screw connection with medium strength thread locker (e.g. Loctite 241).
► Always replace self-locking screws and nuts with new self-locking screws and nuts after disassembly.
Fine fitting/adjusting work should always be performed with the user. The user should sit upright in the power
wheelchair while adjustments are made.
All parts of the product should be cleaned thoroughly before adjustments are made.
The tools required for adjustments and maintenance tasks as well as the torque values for screw connections are
listed in the section "Appendices" (see Page 20).

6.2 Basic settings

The following fitting tasks are described in more detail in the included Instructions for use (user):
• Adjusting the belt length
• Adjusting the position of the control panel
• Adjusting the luggage carrier

6.3 Adjusting the back support height

The backrest height can be adapted to the height of the user.
Depending on anatomic back compensation, the backrest moves down when bringing it in the upright position. In
the standing position the back strap should be tight.
10 C1000 SF