Settings and assembly instructions
7.6 Adjusting the back support upholstery
Back support upholstery, standard
The back support upholstery tension can be easily adjusted:
1) Open the four hook-and-loop closures at the rear (see fig. 12, item 1).
2) Refasten the hook-and-loop straps in the new length position.
The back support upholstery can be adjusted in height by one increment (25 mm):
1) Remove the Phillips head screw on each side (see fig. 13, item 1).
2) Move the back support upholstery to the desired height (see fig. 13, item 2).
3) Insert the Phillips head screw on each side and tighten to max. 2 Nm (not illustrated).
12
7.7 Installing and adjusting the leg supports
The required legrest height depends on the lower leg length of the user and the thickness of the seat cushion.
7.7.1 Segmented leg supports
Installing the leg support
For removing and attaching the leg supports: see Page 21 .
Adjusting the lower leg length
1) Remove the cotter pin from the leg support (see fig. 14, item 1).
2) Adjust the leg support height (see fig. 14, item 2).
3) Install the cotter pin in the leg support.
14
Adjusting the foot plate angle
1) Loosen the countersunk head screw on the foot plate (see fig. 15).
2) Turn the foot plate to the desired angle (see fig. 16).
3) Tighten the countersunk head screw to at least 6 Nm (see fig. 15).
16
13
Start B2