Turn On The Dia-Illumination Lamp - Nikon Eclipse Ni-E Instruction Manual

IR-DIC Microscopy
Display at power on
When the power is turned on, operation progress
is displayed on the front display panel of the main
body.
When initialization completes, microscope's status
appears on the display panel. For details, see
Chapter 3, "1 Display Panel Details".
2

Turn on the dia-illumination lamp.

Press the dia-illumination lamp ON/OFF switch.
Lamp ON, brightness adjustment
operation control
The lamp can also be turned on and adjusted from
DS-L3 by configuring the lamp control button on
the DS-L3's [MICROSCOPE CONTROL] screen
or [CAM-MIC] screen. When Ni-E is turned on,
control switches on the Ni-E are enabled.
To control from DS-L3, switch the control to the
DS-L3 side by pressing the [LAMP CTRL] button
configured on DS-L3. When the button is checked,
the microscope can be controlled from DS-L3.
Chapter 2
Microscopy Operations
Preparation
Procedure
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 ■
13
Focus and Orientation Microscopy
_ N i - E _ V x . x x _ x x x x . x x x x . F 1
D a t a _ L o a d i n g . . .
Top: Model name, firmware version
Bottom: Program startup progress
_ N i - E _ V x . x x _ x x x x . x x x x . F 1
I n i t i a l i z i n g . . . . . . . . . . . .
Top: Model name, firmware version
Bottom: Motorized device initialization
progress
_ _ _ _ _ _ _ _ _ _ Z :
D I A : O N _ _ _ _ _ _ _ _ _ _
Microscope state display
Display pattern 1: Factory setting example
Turning on dial-illumination lamp
_ _ _ _ _ _ _ _ _ _ Z :
D I A : O N _ _ _ _ _ _ _ _ _ _
Voltage is not displayed.
DS-L3 [MICROSCOPE CONTROL] top screen
[MIC] button: Switching to MICROSCOPE
CONTROL screen
[MICROSCOPE CONTROL] screen
[LAMP CTRL] button: Switch lamp control.
[LAMP ON/OFF] button: Turn on/off the lamp.
[ADJ.] button: Open the sub screen for
brightness control.
[PHOTO] button (on the sub screen):
Photomicrography voltage.
_ _ _ _ _ 0 . 0 0 0 u m
F S 3 0 . 6 m m
_ _ _ _ _ 0 . 0 0 0 u m
F S 3 0 . 0 m m