Nikon Eclipse Ni-E Instruction Manual page 110

(5) Setting Mode Function (See DS-L3 Chapter 5 "2 Using the MODE Function".)
In order to use the MODE function, "register" the motorized devices for the modes and "save" the status of the registered
motorized device. "Load" the saved mode on the [MICROSCOPE CONTROL] screen.
See Chapter 3 "18.1 Mode Function" in this document for the details on the MODE function.
(5-1) Registering Mode (Add/Modify/Delete)
(See DS-L3 Chapter 5 "2.1 Registering/Changing Target Motorized Devices
(See DS-L3 Chapter 5 "2.4 Deleting a Mode".)
<Factory setting>
Mode name [MD1] to [MD8]: Not registered
Specify a mode number to open a sub-menu. [Add] button is
displayed for an initial registration and [MODIFY] and [DELETE]
buttons for a registration update, so follow the instruction on the
screen to enter a mode name (up to four alphanumeric
characters) and specify a target motorized unit.
When you "delete" the mode, its mode name will change to the
factory default name (MD1 to MD4).
(5-2) Saving a mode
(See DS-L3 Chapter 5 "2.2 Saving/updating a Mode
(State of Motorized Devices)".)
After the mode has been registered, the mode name registered
for the [MODE (No.)] button is displayed and the [SAVE MODE]
button is displayed on the right of the button. Let the microscope
enter your desired microscopy state here and press the [SAVE
MODE] button, then the current position and state (mode) of the
registered motorized unit will be saved.
You can also save the mode on the [MICROSCOPE CONTROL]
screen. See the following figure (5-3). Press the [SAVE MODE]
button to open the submenu. Set the desired microscopy state
using the microscope and press the corresponding mode
number button to save the current microscopy state for the
registered motorized device.
(5-3) Loading a mode
(See DS-L3 Chapter 5 "2.3 Loading a Mode".)
The saved mode can be recalled on the [MICROSCOPE
CONTROL] screen.
Press the [LOAD MODE] button to open the submenu. Specify
the number of the mode to be loaded.
Chapter 3
Individual Operations
Specifying mode NO. → Adding/modifying/deleting
[LOAD MODE] button
96
[SETUP MENU] → [MODE]
mode
Registered mode
(Example: MODE1 and MODE2 registered)
[MICROSCOPE CONTROL] screen
[SAVE MODE] button
Saving a mode: [SAVE MODE] button
→ Press the [MODE No.] button for the mode
to be saved in the submenu.
Loading a mode: [LOAD MODE] button
→ Press the [MODE No.] button for the mode
to be loaded in the submenu.