Nikon Eclipse Ni-E Instruction Manual page 119

Operation Button
[SHUTTER INTSL]
[SHUTTER EPI]
[SHUTTER]
[SHUTTER DIA]
[SHUTTER AUX]
[CAPTURE FRONT]
[CAPTURE] [CAPTURE LEFT]
[CAPTURE AUX]
[SAVE]
[LOAD] [LOAD (MODE number)]
[Z-axis RESET]
[XYZ]
[Specimen Removal Position]
Chapter 3
Individual Operations
Open/close the built-in shutter in
the HG precentered fiber
illuminator. (Equivalent to the
[SHUTTER INTSL] button on the
[INTSL] sub screen.)
Open/close the EPI motorized
shutter.
Open/close the DIA motorized
shutter.
Open/close the AUX motorized
shutter.
Output the capture trigger signal
to the digital camera connected to
the tube adapter.
Output the capture trigger signal
to the digital camera connected to
the DSC zooming port.
Output a capture trigger signal to
a digital camera connected to a
position other than the above.
Save the current microscopy state
as a MODE.
Load a saved MODE.
Reset the Z-axis coordinate
displayed on DS-L3 to zero (0).
Move the microscope's elevating
section to the retracting position.
Press the button again to restore
it to the original position.
[ESCAPE]
Move the microscope's elevating
section to the retracting position,
and the motorized XY stage to the
sample removal position (front).
When you press this button again,
only the motorized XY stage
returns to its original position.
105
Function Reference in DS-L3
Instruction Manual
Chapter 5 "1.12.1
Opening/Closing the
Motorized HG Precentered
Fiber Illuminator's Built-in
Shutter"
Chapter 5, "1.16
Opening/Closing the
EPI/DIA/AUX Motorized
Shutter"
Chapter 5, "1.17 Outputting
Capture Trigger Signals from
the Microscope"
Chapter 5, "2.2
Saving/Updating a Mode
(State of Motorized
Devices)"
Chapter 5, "2.3 Loading a
MODE"
Chapter 5, "1.18.1
Zero-resetting the Z-axis
Coordinate"
Chapter 5, "1.18.2
Retracting the Elevating
Section"
Chapter 5, "1.18.3
Retracting the Elevating
Section and Moving the
Stage to the Specimen
Removal Position"
Operation