10. Service Mode
10.9.9
Line Mag Setting
Functions
• To set whether to use the offset value which has been set prior to the shipping.
Use
• To be used after replacing the CCD unit.
After replacing the CCD unit, the default value needs to be set since the magnifica-
tion offset value between the lines set for each unit changes to control the differences
in reading performance on each scanner (CCD).
• The original offset value can be disabled to address image failure and other problems
caused by individual CCD performance difference.
Setting/
• The default setting is ON.
Procedure
NOTE
• When the setting is changed, the function becomes valid by turning the sub
power switch OFF and ON again.
398
"ON"
Field Service Ver. 3.0 Jan. 2008
OFF