Konica Minolta bizhub C353 Service Manual page 904

Field Service Ver. 3.0 Jan. 2008
2.1.3 Lubricating the worm gear and replacing the cover film
A. Periodically lubricated parts/cycle
• Worm gear: Every 800,000 prints
B. Periodically replaced parts/cycle
• Cover film: Every 800,000 prints
C. Procedure
NOTE
• Before the following lubrication and replacement work, make sure to remove
optional SD-505 and MT-502 when the finisher is equipped with these options.
1. Turn the main and sub power switch ON. Then turn the main power switch OFF when
the tray reaches the lowest position during the initial operation.
2. Remove the tray unit rear cover.
See P.23
[2]
[1]
[2]
[1]
A01GF2C559DA
A01GF2C560DA
2. Periodical check
3. Remove the wire saddle [1] and dis-
connect the connector [2].
4. Remove the wire saddle [1] and the
screw [2]. Remove the ground termi-
nal.
11