Konica Minolta bizhub C353 Service Manual page 499

14. Mechanical adjustment
14.1.4 Adjusting the height of the original glass moving unit
This adjustment must be made in the following case:
• When replacing the original glass moving unit.
[1]
[2]
454
[2]
A00JF3C010DA
[1]
A00JF3C011DA
[1]
[2]
A00JF3C012DA
Field Service Ver. 3.0 Jan. 2008
1. Set the height adjustment jig for the
original glass moving unit [1].
Insert the paper [2] between the orig-
inal glass and the height adjusting jig
for the original glass moving unit.
2. Press the height adjusting jig for the
original glass moving unit [1] on the
original glass moving unit side [2].
3. Pull the paper [2] while pressing the
height adjusting jig for the original
glass moving unit [1] and make sure
that the paper will not come out.
NOTE
• Pull the paper [2] while pressing the
height adjusting jig for the original
glass moving unit [1] and make
sure that the paper will not come
out.
4. When the paper comes off, the
adjustment of the height is neces-
sary by the following procedure.