Konica Minolta bizhub C353 Service Manual page 780

Field Service Ver. 2.0 Jan. 2008
[3]
[1]
[2]
A01HF3C517DA
[2]
[1]
A01HF3C518DA
7. Mechanical adjustment
7. Loosen the mounting screw [1] on
the right hinge viewed from the front.
8. When the difference of the deviation
is + (plus), turn the screw [2] coun-
terclockwise to adjust.
NOTE
• When turning the screw, be sure
not to raise the reverse automatic
document feeder until in an upright
position.
• When the adjusting plate [3] is set
far left, do not tighten any further.
• To prevent the adjustment screw [2]
breakage, be sure to follow the
above instructions.
9. When the difference of the deviation
is - (minus), turn the screw [1] clock-
wise to adjust.
10. After the adjustment is completed,
tighten the mounting screw [2] on
right side hinge securely with screw-
driver.
35