Mechanical Adjustment; Adjusting The Height - Konica Minolta bizhub C353 Service Manual

Field Service Ver. 2.0 Jan. 2008
7.

Mechanical adjustment

7.1

Adjusting the height

NOTE
Make this adjustment after any of the following procedures has been performed.
• When the reverse automatic document feeder has been reinstalled.
[1]
[2]
[1]
A01HF3C513DA
A01HF3C514DA
[1]
A01HF3C515DA
7. Mechanical adjustment
1. Check the clearance between the
upper face of scanner and the pro-
trusion [1] on the reverse automatic
document feeder side (2 spots, front/
back).
NOTE
• There must be no clearance
between the protrusion [1] on the
reverse automatic document feeder
and the upper face of scanner.
2. If there is any clearance, the follow-
ing adjustment is needed.
3. Remove the label [1].
4. Remove the clearance by turning the
adjusting screw [1].
Clockwise rotation:
Lifting up the rear side
Counterclockwise rotation:
Lowering the rear side
5. Use the adjusting screw [2] when fur-
ther adjustment is needed.
Clockwise rotation:
Lifting up the rear side
Counterclockwise rotation:
Lowering the rear side
6. Affix again the labels removed in
step 3.
33