Konica Minolta bizhub C353 Service Manual page 196

Field Service Ver. 3.0 Jan. 2008
[1]
B. Reinstall procedure
[2]
[2]
[1]
[4]
[4]
[2]
A00JF2C269DA
[1]
[2]
A00JF3C538DA
[3]
[2] [4]
A00JF3C526DA
10. Remove two screws [1], and remove
the scanner motor [2].
1. Temporarily secure the scanner
motor assy [1] with three screws [2].
2. With the scanner drive gear set
screw [1] located on the right-hand
side as shown on the left, slide the
scanner motor assy [2] to the left and
check that it is returned to the origi-
nal position by the tension of the
spring [3].
Perform this step three times.
3. Turn the pulley and make sure that
the belt does not ride up on the pul-
ley teeth.
4. Tighten the three screws [4] to fix the
scanner motor assy into position.
6. Other
151