Finisher Unit - Konica Minolta bizhub C353 Service Manual

3. Other
3.4.12

Finisher unit

1. Remove the tray unit.
See P.25
[2]
28
11. Pull the lock release lever [1] and
[1]
NOTE
• Make sure the height and angle
adjustment of stand table when
installing the finisher.
A01GF2C512DA
2. Disconnect the hookup cord [1].
[1]
A01GF2C572DA
3. Hold the positions as shown in the
NOTE
• When setting the finisher unit,
make sure to fit the finisher unit
hole with stabilizing pin [2] and set
it to the end.
• Make sure the height and angle
adjustment of stand table when
[1]
installing the finisher.
A01GF2C573DA
Field Service Ver. 3.0 Jan. 2008
remove the tray unit.
See P.34
illustration to remove the finisher unit
[1].
See P.34