Pwb Box - Konica Minolta bizhub C353 Service Manual

Field Service Ver. 3.0 Jan. 2008
[1]
[1]
[2]
NOTE
• When the MFP board is to be replaced, rewriting the firmware to the latest one.
6.3.46

PWB box

1. Remove the rear right cover/1 and the rear right cover/2.
See P.91
2. Remove the lower rear cover/1 and the lower rear cover/2.
See P.93
3. Remove the hard disk drive and the metal plate.
See the steps 1 to 6 of printer control board removing procedure.
See P.136
[2]
[3]
A02EF2C146DA
[1] [3]
[1]
A02EF2C147DA
[1] [2]
[1]
[2]
A02EF2C148DA
7. Remove five screws [1] and six bolts
[2], and remove the metal plate [3].
8. Remove twelve screws [1] of the
MFP board.
9. Slide the MFP board [2] in the direc-
tion of the arrow, disconnect the con-
nector [3], and remove the MFP
board.
4. Remove the harness from four edge
covers [1] and seven wire saddles
[2].
6. Other
139