4. Other
4.3.3
Rear cover
3. Open the transportation cover.
4. Lift up the document feed tray.
[2]
A. Reinstallation procedure
1. Open the transportation cover.
2. Lift up the document feed tray.
[1]
18
[1]
A01HF2C012DA
[1]
[3]
A01HF2C023DA
[2]
A01HF2C024DA
Field Service Ver. 2.0 Jan. 2008
1. Open the reverse automatic docu-
ment feeder.
NOTE
• If the reverse automatic document
feeder is set to be lifted up at
angles up to 60 degrees due to the
set position of the stopper for the
hinge, change the set position to
the lower side so that the reverse
automatic document feeder can be
opened completely.
2. Remove two screws [1].
5. Remove the screw [1] and remove
the rear cover [2].
NOTE
• Be sure to press down part [3] in
the picture to prevent any damage
when removing the rear cover.
3. Press down part [1] in the picture
until it slides under the feed cover [2].
NOTE
• Be careful not to damage the rear
cover.
4. Install the rear cover tightening three
screws.