Punch Horizontal Position - Konica Minolta bizhub C353 Service Manual

Field Service Ver. 3.0 Jan. 2008
6.1.3

Punch Horizontal Position

<Inch area: 2 holes>
A
<Metric area: 4 holes> <Sweden: 4 holes>
A
4. Call the Service Mode to the screen.
5. Touch [Finisher].
6. Touch [CB-FN adjustment].
7. Touch [Punch Horizontal Position].
<Inch area: 3 holes>
A
A
4512F3E502DA
A01GF3E507DA
6. Finisher operations
1. Set the copier into the hole punch
mode and make a 1-sided copy from
a 1-sided original.
2. Measure width A on the copy and
check to see if the measured dimen-
sion falls within the specified range.
<Inch area: 2 holes, 3 holes>
Specifications: 9.5 ± 1.0 mm
<Metric area: 4 holes>
Specifications: 11 ± 1.0 mm
<Sweden: 4 holes>
Specifications: 11.5 ± 1.0 mm
3. If the measured width A outside the
specified range, perform the follow-
ing procedure to punch hole position
adjustment.
8. Set the correction value using the
[+]/[-] keys.
• To make width A wider, enter a posi-
tive value.
• To make width A narrower, enter a
negative value.
• Adjustment range: +10 max. and -10
min. (1 increment: 0.5 mm)
9. Touch two times [END].
10. Touch [Exit] on the Service Mode
screen.
11. Turn OFF the main power switch,
wait for 10 sec., then turn the switch
ON.
12. Make a copy and check the punch
hole positions again.
65