Field Service Ver. 2.0 Jan. 2008
4.3.6
DF control board
1. Remove the rear cover.
See P.18
[2]
4.3.7
Document width detection variable resistor
1. Open the feed cover.
See P.16
[1]
[2]
A01HF2C025DA
[2]
[1]
[3]
A01HF2C026DA
A01HF2C015DA
2. Disconnect all the fifteen connectors
from the DF control board.
3. Remove the screw [1].
4. Remove four screws [2] and remove
the DF control board [3].
NOTE
• Be sure to perform the following
operation when the DF control
board is replaced.
5. Replace the EEPROM.
6. Upgrade the firmware.
See P.50 of the main body service
manual.
2. Disconnect the connector [1] and
remove the document width detec-
tion variable resistor cover [2].
4. Other
21