Replacing The Pick-Up Roller - Konica Minolta bizhub C353 Service Manual

2. Periodical check
2.1.3

Replacing the pick-up roller

A. Periodically replaced parts/cycle
• Pick-up roller: Every 300,000 prints
NOTE
• Replace the separation roller assy, feed roller and pick-up roller at the same time.
B. Replacing procedure
1. Remove the right door.
See P.12
2. Remove the rear cover and the rear right cover.
See P.12
[1]
[1]
[2]
8
[2]
[1]
A093F2C500DA
A093F2C509DA
[3]
[1]
A093F2C010DA
Field Service Ver. 3.0 Jan. 2008
3. Remove two screws [1] and separa-
tion roller mounting bracket assy [2].
4. Insert a driver into the hole [1] at the
back of the feed tray and pull out the
paper feed tray.
5. Remove two wire saddles [1] and
four screws [2], and remove the
paper feed unit [3].