3. Other
3.4.14
Height and angle adjustment of stand table
3. Pull the lever to unlock it, and remove the tray unit from the main body.
[1]
[1]
[1]
34
X
A01GF2C574DA
[1]
A01GF2C575DA
A01GF2C576DA
Field Service Ver. 3.0 Jan. 2008
1. Measure the width of X on front and
back side.
Specifications: 5 ± 2 mm
2. Following adjustment is necessary
when the width does not fall within
the specifications.
4. Remove two covers [1] from the legs
of the stand table.
5. Loosen four screws [1] (two screws
each for the left and right) and adjust
the height of the stand. Tighten the
screws again.