Line Mag Setting; Data Capture - Konica Minolta bizhub C650 Service Manual

Field Service Ver. 8.0 Jun. 2008
10.9.10

Line Mag Setting

Functions • To set whether to use the offset value which has been set prior to the shipping.
Use • To be used after replacing the CCD unit.
After replacing the CCD unit, the default value needs to be set since the magnifica-
tion offset value between the lines set for each unit changes to control the differences
in reading performance on each scanner (CCD).
• The original offset value can be disabled to address image failure and other problems
caused by individual CCD performance difference.
Setting/ • The default setting is ON.
Procedure
NOTE
• When the setting is changed, the function becomes valid by turning the sub
power switch OFF and ON again.
10.9.11

Data Capture

Functions • When an error occurs, it acquires the print job data in order to analyze the cause of
the error.
Use • When an error occurs, this will be used to analyze the cause of the error according to
the print job data.
Setting/ NOTE
• The following conditions are necessary for this function.
Procedure
When selecting [Security Setting] → [Security Details] → [Print Data Capture]
in Administrator Settings, [Allow] must be set.
The hard disk must be mounted to the machine.
When selecting [Administrator Settings] → [Network Settings] → [FTP Set-
tings], [FTP Server Settings: ON] must be set.
• This function is not available when the optional image controller IC-409 is
2
mounted.
1. Select [Service Mode] → [System 2], and touch [Data Capture]. Select [ON].
(While the Data Capture setting is [ON], the print job data from the PC will be stored
in the hard disk.)
NOTE
• The original offset value can be disabled to address image failure and other
problems caused by individual CCD performance difference.
2. Check the IP address of the machine.
3. Connect the PC (Windows) and the machine with ethernet cable.
4. Start the DOS command prompt of the PC, and specify the IP address of the
machine to start FTP.
"ON"
10. Service Mode
OFF
4037F3E538DA
499
2