Action When Data Transfer Fails - Konica Minolta bizhub C353 Service Manual

3. Firmware upgrade
NOTE
• When turning the main power switch ON for the first time after the firmware is
updated, data may sometimes be internally updated.
In that case, the following message will be displayed. Never turn the main power
switch OFF until either the serial number input screen or the trouble code screen
is displayed.
13. Call the Service Mode to the screen.
14. Select [Firmware Version].
15. Make sure if the version of firmware is updated.
3.5.2

Action when data transfer fails

• If "NG" appears on the control panel, indicating that rewriting has been unsuccessful (in
which case the Start key lights up red), take the following steps.
1. Perform the data rewriting procedure again.
2. If the procedure is abnormally terminated, change the compact flash for a new one and
try another rewriting sequence.
3. If the procedure is still abnormally terminated, change the board that has caused "NG"
and carry out data rewriting procedure.
MFP CONTROLLER
SCANNER
PRINTER
FAX BOARD CONTROLLER1 Fax board (Main) *1
FAX BOARD CONTROLLER2 Fax board (Sub) *2
ADF (DF-M)
FINISHER
*1: The optional fax kit is necessary for the above procedure.
*2: The optional fax multi line ML-501 is necessary for the above procedure.
*3: The optional finisher FS-519 or FS-609 is necessary for the above procedure.
1
22
1
MFP board (MFPB)
Image processing board (IPB)
Printer control board (PRCB)
DF control board (DFCB)
FS control board (FSCB) *3
Field Service Ver. 3.0 Jan. 2008
A00JF2E582DA