10. Service Mode
10.9.9
Line Mag Setting
Functions
• To set whether to use the offset value which has been set prior to the shipping.
Use
• To be used after replacing the CCD unit.
After replacing the CCD unit, the default value needs to be set since the magnifica-
tion offset value between the lines set for each unit changes to control the differences
in reading performance on each scanner (CCD).
Setting/
• The default setting is ON.
Procedure
NOTE
• When the setting is changed, the function becomes valid by turning the Sub
Power Switch OFF and ON again.
270
"ON"
Field Service Ver. 1.0 Jul. 2005
OFF