Paper Feed Tray 1 Lift-Up Motor (M8) - Konica Minolta bizhub C353 Service Manual

6. Other
6.3.63

Paper feed tray 1 lift-up motor (M8)

1. Remove the tray 1.
See P.95
2. Remove the tray 2.
See P.95
3. Remove the right front cover/2.
See P.85
4. Remove the lower rear cover/1 and the lower rear cover/2.
See P.93
5. Remove the protective shield/1 and the protective shield/2.
See the steps 1 to 5 of printer control board removing procedure.
See P.136
[1]
[3]
[4]
158
[1]
[1]
A02EF2C541DA
[1]
[2]
[1] [1] [1]
A02EF2C542DA
[2] [1]
A02EF2C161DA
Field Service Ver. 3.0 Jan. 2008
6. Disconnect two connectors (CN10,
CN11) [1] on the printer control
board.
7. Remove the harness from five wire
saddles [1] and the edge cover [2].
8. Disconnect the connector [1], and
remove the harness from the edge
cover [2].
9. Remove three screws [3], take out
the paper feed tray 1 lift-up motor
assy [4].