Serial Number; No Sleep; Foolscap Size Setting; Original Size Detection - Konica Minolta bizhub C353 Service Manual

Field Service Ver. 3.0 Jan. 2008
10.8.3

Serial Number

Functions • To register the serial numbers of the machine and options.
• The numbers will be printed on the list output.
• To use the serial number as Machine ID during CS Remote Care communication.
Use • Upon setup.
NOTE
• When main power switch was turned ON while the serial No. was not entered,
the message to require entering the serial No. will be displayed.
• Do not change the serial number registered in the machine. If memory data is
lost and entering the serial number is required, enter the original correct serial
number.
Be careful to enter the correct serial number since characters other than
alphanumeric can be also entered. CSRC communication is not available if a
wrong serial number is entered.
Setting/ • Type the serial numbers.
Procedure Printer, Scanner, ADF, LCT, Sorter/FN, Duplex, Vendor, Fax1, Fax2
10.8.4

No Sleep

Functions • To display the option of "OFF" for the sleep mode setting screen available from
administrator settings.
Use • To display the option of "OFF" for the sleep mode setting.
NOTE
• The sleep mode will begin in 48 hours even if it sets it to "OFF."
Setting/ • The default setting is "Prohibit."
Procedure
10.8.5

Foolscap Size Setting

Functions • To set the size for foolscap paper.
Use • Upon setup.
• To change the size for foolscap paper.
Setting/ • Select the size from among the following five.
Procedure
220 x 330 mm
10.8.6

Original Size Detection

Functions • To change the document size detection table.
Use • Use to change the setting for the document size detection table.
Copy Glass : To change the size detection table for the document glass.
Setting/ <Copy Glass>
Procedure • The default setting is "Table1."
NOTE
• Table 2 can be set only when original size detection 2 sensor is being
mounted.
Permit
8 / x 13 8 / x 13
1 1
2 4
"Table1"
10. Service Mode
"Prohibit"
8 / x 13 / 8 x 13
1 1
8 4
Table2
389