Figure 2-38 No Answer Display - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

If the VRS message is not recorded, a tone is provided.

Emergency call destination must be set considering this feature's purpose.

The emergency number dialed does not follow ARS settings:

If Program 13-01-01 is set to Trunk the system uses command Program 13-05 to route the

emergency call.

If Program 13-01-01 is set to ICM the system uses command Program14-06 to route the

emergency call.

If remote inspection target does not answer, display below sentence to terminal which set

Program 20-08-24 data to 1.

Press Exit, display returns to idle.

Emergency Call 1

Emergency calls when Security Sensor or Remote Inspection performed, SMDR can record

these call class as follows:

Security Sensor: SAD

Remote Inspection: WAD

Emergency Call 2

When Security Sensor or Remote Inspection performs an Emergency call, alarm reports are

recorded and the alarm display terminal indicates the following:

Security Sensor: 31: Sensor Detect

Remote Inspection: 32: Confirm Dial

Recording Emergency Call

By setting Program 90-20-11 (1; Report) Emergency calls can be recorded on security report.

Maximum of 50 records can be saved.

Figure 2-38 No Answer Display

Table of Contents